Easyinsmile Dental Laser Pindex Pin Drill Machine Plastic Board Lab Equipment

Easyinsmile Dental Laser Pindex Pin Drill Machine Plastic Board Lab Equipment

Feature:
1. Trim the models coming from Dental clinics or dental hospitals. Cut off the Rubber Siligum which is over 10mm far from Gum edge, try best to make it tidy；
2. Choose the Plastic Board according to the model tray
3. Put the tray close the steel plate top part，insert the board in the gap，adjust the relatively place between tray and board
4 .Put the circle plate，fill the gap with Rubber
5. Put the board inside the gap and tighten the screws
6. Put it on the surface of Pindex machine，
7. Insert the pins inside the holes
8.Mix the plaster and put the plaster inside the model
9. One hours later ,the plaster got dry .Use the saw to cut off some
10. Put the magnetic plate in the middle of board

Specification:
Voltage:(A)220V/50Hz+-10% (B)110V/60Hz+-10%
Power:160W
Rotational speed:15000rpm
Dimension:18*18*33cm

Statement(FDA,ARTG)
The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item.